Correct operation of GW50 Manual Bending Machine should pay attention to the details of what matters

    If everyone comes to GW50 Manual Bending Machine, I think there may be some people still heard, although not closely linked with people's lives, but its scope is very broad. The use of such a large device will certainly there is a certain degree of risk, so how to properly use, operation of the device is worth every staff learning, and today we take a look, hope can help staff correctly.
Before first use, do not worry turn on the power to enter use, you should first check the mechanical performance is not good, bench and table bending machines must maintain a level of state, and we must do a variety of mandrel tool block. Installation should be in accordance with the mandrel diameter and bending rebar processing machine to match, and the mandrel diameter should be 2.5 times the bar diameter.
    Secondly, we must check the mandrel, the stopper, the turntable so the details are not places where there is damage, such as cracks, shield is not fastened, if you find any problems with the details, to adjust to solve the problem immediately. Empty after running for a while, if confirmed to be functioning normally, and then enter into formal operation.
    Thirdly, the formal entry into the job, should be inserted in a steel turntable fixed with a gap inside the other end should be close to the body fixed and pressed his hand tightly, to ensure the body is fixed.
    Then, in the device operation,GW50 Manual Bending Machine is not able to replace the spindle, change the angle, but also remember not to refuel or clear, these should be good to check before the device is running, avoid experiencing more trouble.
    In addition, equipment operation, is strictly prohibited within the operating radius of GW50A Máquina Doblado automático and the body does not have a fixed side stop people, to avoid damage to the surrounding people.
    Finally, after the job is completed, to clean up the site, maintenance equipment, especially important to de-energized.
    More to tell you is about how to properly operate GW50 Manual Bending Machine, these are very important, and many of them are reflected in the details of the place, in fact, details are very important, and often is a detail of the problem could lead to more big problem. So, I hope the above considerations employees can pay attention to it, the safe operation of equipment that is the most important.