2. Do not place the power cable to GW50A Automatic Bending Machine 's buttons, you should have received an additional control power switch. The motor should be grounded, ministries wire, electrical equipment should be well insulated.
3, The operation is prohibited other personnel into the operating area, running the motor, hydraulic pumps and other transmission parts found abnormal noise should stop after cutting the power for maintenance. Operation prohibit cleaning, lubrication.
4, We must add a little oil before use. Not use less than blocked shaft GW50A Automatic Bending Machine diameter bend, bend steel must first straightening work shall not be bent.
5, After work, turn off the power, mechanical cleaning and maintenance work. If outside, before leaving after the power switch box should be locked.
6, Should pay attention to before starting the position and direction of bending steel protruded prevent open the wrong wounding.
7, The work should be checked before each transmission parts fastening bolt through the rear idle test confirmed safe before doing any work.
8. Replace the bent pin and a fixed pin midnight on the turntable, GW50A Automatic Bending Machine should cut off the power to stop the rotation after.
没有评论:
发表评论